Merry Medallion Quilt-Along: Putting it all Together!

Merry Medallion - Putting It All Together!

Yay! Almost there! This week’s tutorial will put everything together, which is a lot of pinning and sewing, but really not very many seams to sew. You’ve already done the hardest work. By the end of this post, you’ll have a completed quilt top – hurrah!!

What You’ll Need

Merry Medallion - Putting It All Together!

– your three low volume half-meter cuts
– and one mid-volume fat quarter

Cutting The Pieces

Before anything else, we have to cut up those fabrics above. I didn’t have you cut these fabrics at the beginning, with the others, because seeing all the other elements together might help determine which of these fabrics you use where. I didn’t decide on my ‘mid-volume’ fabric until yesterday, and the arrangement of fabrics for my border rounds (this isn’t exactly the right term, but these rounds are more than sashing, so we’ll stick with ‘borders’) fell perfectly into place once I laid all the bits on the floor. So, if you look at this quilt diagram:

Merry Medallion Borders

You’ll see each border round marked with a label, numbered from the inside working outward. Choose which fabric will be Border 1, which will be Border 2, etc. Then cut:

Merry Medallion - Putting It All Together!

Border 1:

– With fabric folded (as shown above, the fold on the left), cut four 3.5″ strips across the width of the fabric. Take care that the fold is perfectly perpendicular to your cuts, or you’ll end up with v-shaped strips!
– Without moving the fabric, trim down each of those strips to 24.5″. Note: measure out 12.25″ from fold to end up with 24.5″ strips.
– You’ll end up with four 3.5″ x 24.5″ strips.

Border 2:
– Just as before, with fabric folded, cut four 3.5″ strips across the width of the fabric.
– Without moving the fabric, trim down each of those strips to 42.5″. (Measure 21.25″ from fold, but this will be little more than trimming off the selvedge edges.)
– You’ll end up with four 3.5″ x 42.5″ strips.

Border 3:
– One last time, with fabric folded, cut six 2.5″ strips across the width of the fabric.
– Cut two of these strips in half (along the fold crease), then sew a half-strip to the end of each full-length strip to make four really long strips. Trim each to 56.5″ and press seam opens.
– You’ll end up with four 2.5″ x 56.5″ strips.

Mid-Volume Fabric:
– (8) 3.5″ squares
– (4) 2.5″ squares

Merry Medallion - Putting It All Together!

Prepping Borders

Prepping your borders is easy-peasy and will take less than five minutes. Ready? On two strips of each border fabric, sew an equal-sized mid-volume square to both ends. This is exactly what we did with the diamond-blocks last week. The strips are long enough that you can even chain-piece this step, feeding one end in right after the other.

Merry Medallion - Putting It All Together!

Just like last week, for each border round, you’ll have two plain strips and two strips with mid-volume squares on either end.

Final Assembly!

Here we go! All the pieces are ready and they just need us to slap ’em together. We’ll put everything together in rounds, working from the center star outward, and attaching each round will be exactly the same as the first.

Pin your two shorter Border 1 strips to the top and bottom of your center star. Sew all the way across and press seams towards the border.

Merry Medallion - Putting It All Together!

Then pin your two longer Border 1 strips to the sides of your center star, lining the corner squares up with the previously attached border on each end. Sew all the way across and press seams towards the border.

Merry Medallion - Putting It All Together!

That’s it! Simply repeat that same process until your quilt is all finished, one round at a time – the short geese strips on top and bottom of your center section, press towards border, then the long geese strips on each side, press towards border (take care to make sure your geese are flying in the same direction!). Then Border 2, then the HSTs, then Border 3 – and that’s it! Seriously, that’s really it – you’re done!

Merry Medallion - Putting It All Together!

My only comment on putting it all together is that the math for medallion quilts really depends on every tiny seam of the previous round being perfectly accurate. That sounds obvious, but think about each of those geese being off by a tiny bit, you could work up to a half-inch off by the time you tally it all up. Chances are very good that some of your strips will end up being a little bit off – mine totally were, and a little bit more so as I got to the outermost rounds. I mean, c’mon, nobody’s seams are really that perfect, are they? If you are off a little, it’s probably just a very little, and you should be able to just ease that difference in along the seam – when you pin, make sure that any excess of one side is distributed evenly along the seam, and you’ll be fine!

Finishing (When You’re Ready)

Merry Medallion - Putting It All Together!

I promised you a finished quilt top in a month and you did it! Pat your darn self right on the back. I really, really hope you love your quilt as much as I love mine!! We now have four full months to quilt and bind our Merry Medallions to have them ready by the beginning of December – this series won’t go into these steps, but you can follow these tutorials to complete your quilt, down to the very last stitch:

Merry Medallion - Putting It All Together!

I hope you’ll email me or leave a comment on these posts if you make a Merry Medallion of your own – there’s seriously nothing I love more than seeing your versions of projects. And of course, I’ll be back sooner or later to show you my finished quilt!

Merry Christmas in July, peeps!

1 Comment on Merry Medallion Quilt-Along: Putting it all Together!

  1. Andrée
    August 3, 2015 at 13:11 (2 years ago)

    Hi Julie, I haven’t been following you on the quilt-along, but your quilt is really lovely!

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *

Comment *