Ok, are we ready for the next step? Here’s all of my 6″ squares, 144 of ’em:
But don’t worry if you haven’t cut all of your squares yet – in fact, you’ll only need one to follow this week’s tutorials, and then you can go ahead and cut one at a time if you like, it’s totally up to you.
So let’s learn how to make peels!
First you’ll need a peel template – here’s one I prepared earlier:
You can print the template, cut it out, then trace it on to card or a thin cardboard (like a cereal box, for example) – or you can simply print directly onto card (which is what I did). The point is to have a sturdy template, because you’ll be tracing it quite a few times.
(Note: when you print, make sure to print to actual size or choose ‘no scaling’ – and the template includes a 1″ block for testing, so double-check that before you continue.)
Using your sturdy template, you will trace the peel shape onto your freezer paper and cut out the applique shapes:
Technically, you’ll need one freezer paper peel per finished peel (so either 36, or 144, or your custom number), but in theory, you *should* be able to reuse them at least once, so I suggest cutting no more than half of what you need to start with. I cut about 60 or so, for now.
In case you’ve never used freezer paper before, here’s how you apply it to your fabric. Check out one of your applique shapes – you’ll see one side is shiny and slick and the other side is papery:
The shiny side is what will stick to your fabric. So press one of your peel fabrics and place a freezer paper shape, shiny side down, onto your fabric with 1/4″ seam allowance all around it. With your iron set to cotton (no steam), simply press down on the shape and it will stick to your fabric. It’s magic!
How long you need to press for full stuck-ness will of course depend on your iron, but I usually hold for a few seconds to get an initial stick, then go over everything a few times once I have a few shapes stuck. As you stick multiple shapes next to each other, make sure to leave at least 1/2″ between them!
(Note: for those of you making the wall quilt, you should have plenty of peel fabric to be casual with your placement. If you’re making the lap quilt, you’ll need to get 12 peels from each FQ, so you might want to lay them all out first to make sure they all fit properly before you press. Also, there’s no reason to lay them out diagonal like I have, just lay them out however you like!)
Now with sharp fabric scissors, cut out each peel with at least 1/4″ seam:
I tend to cut with a slightly bigger seam allowance, just because it’s a little easier to manage and it does no harm to have a bit more fabric to hold later – but it’s not necessary.
Now we’ll baste the seams under. If you’ve ever done any English Paper Piecing, this will be very familiar. Grab your basting / scrap thread and a fairly sturdy needle –
– and starting at one pointy end, fold the seam allowance down over the freezer paper:
Knot the thread and pull it through so that the knot is on the right side of your peel. This will will make your basting stitches easier to remove later. Now using big stitches (about 1/4″-ish) and folding as you go, baste through all layers all around the peel.
At the pointy ends, just fold the second side over the first and stitch through all layers. As I said: if you’ve ever paper pieced a hexagon, you’ll know exactly what to do.
Unlike hexagons, though, you’ll notice that your fabric gathers a little as you stitch. That’s totally fine, we’ll press them flat later.
Here’s what your peels should look like, right and wrong side:
And that’s it. As always, let me know if you have any questions, and I’ll show you how to applique your peels to your squares on
Thursday Friday (the 19th)!